Xerox WorkCentre 7132 User Manual page 423

Xerox WorkCentre 7132 User Guide
Downloaded From ManualsPrinter.com Manuals
Code
034-501 The telephone cable may not be connected securely. Check that the telephone
cable is connected correctly, and resend the document. Refer to Telephone
socket in the Product Overview chapter on page 34.
034-505 An error occurred using the fax. Turn the power off and on. Contact the Xerox
Welcome Center if the problem persists.
034-506 The remote copy function (printing multiple copies of a received document) is
not supported on the destination machine. Check if the destination machine
supports the remote copy function.
034-507 Communication failed, because the password you specified does not match with
the ID number of the destination machine. Make sure that the password and
telephone number are correct. The destination machine may be set not to send
its own ID number. This code is also displayed when a polling request is
rejected.
034-508 An error occurred when using the fax. If sending a fax, check the fax setting, fax
034-509 number, and other settings, then perform the same operation again. Contact the
034-510 Xerox Welcome Center if the problem persists.
034-511 A document for relay broadcasting cannot be transmitted. Check that the relay
station is correctly registered in the specified speed dial code. Also, check the
contents of the address number registered at the relay station.
034-513 Received an invalid command. This is a Xerox remote maintenance system
operational error. No user action is required.
034-514 Received an unsupported request. This is a Xerox remote maintenance system
operaional error. No user action is required.
034-512 An endless loop was detected in the remote relay broadcasting. Check that the
relay station is correctly registered in a speed dial number, and check the speed
dial number points to the relay station.
034-515 There is a problem on the remote machine. Check the remote machine status.
034-519 The number of destinations exceeded the maximum number during broadcast
transmission. Wait for the pending jobs to decrease or reduce the number of
destinations, then repeat the same operation.
034-520 The number of jobs to be received exceeds the maximum number. Wait for the
pending jobs to reduce and then repeat the operation.
034-521 An internal error occurred. Turn the power off and on. Contact the Xerox
Welcome Center if the problem persists.
034-522 There is no phone line available for manual send communication. Wait until
current transmissions to end, then perform the same operation again.
034-523 The fax service has been disabled, and jobs cannot be received. Wait a while,
then perform the same operation again.
034-527 A dial control error occurred. Turn the power off and on. Contact the Xerox
Welcome Center if the problem persists.
Description and Remedy
Fault Codes
423