Other Settings - Xerox WorkCentre 7132 User Manual

10 Setups

Other Settings

Print Area
Substitute Tray
Paper Type Mismatch
264
Downloaded From ManualsPrinter.com Manuals
currently available memory will be displayed at the top of the screen with the following
message: "Memory Available: XXX MB."
This feature allows you to specify a printable area and replacement method when
paper runs short.
1.
Select [Other Settings] on the
[Print Mode Settings] screen.
2.
Change the required settings.
Use the scroll buttons to switch
between screens.
3.
Select [Close].
Specifies the printable area. Select [Standard] to crop a margin 4.1 mm (0.16 inches)
wide along all four edges of the paper. Select [Extended] to crop a margin of 2 mm (0.08
inches) along the edges.
Specifies the substitute tray when the machine cannot detect the paper tray
corresponding to the document size with the auto paper selection.
Display Message
Specifies a message prompt requesting paper supply be displayed without switching
paper trays.
Use Larger Size
Specifies switching to the tray loaded with the next larger size of paper and prints the
document in its original size.
Use Closest Size
Specifies switching to the tray loaded with the paper in the size closest to the selected
paper. Image size may be automatically reduced as required.
NOTE: The job sent from the PC takes priority over the job set on the machine.
Select Tray 5 (Bypass)
Specifies switching to the bypass tray.
Specifies whether to print, display the confirmation screen, or display the paper supply
screen when a paper type mismatch occurs.
Xerox WorkCentre 7132 User Guide