Setting "Speaker Location - Denon S-101 Operating Instructions Manual

ENGLISH
System Setup
2
CURSOR •
Press the or
"DISTANCE", then press the
• The distance setting screen appears.
3
CURSOR 0 or 1 button to select
Press the
"FEET" or "METERS" for the "DISTANCE"
CURSOR ª
mode, then press the
4
CURSOR •
Press the or
CURSOR
speaker, then press the
to set the distance between the speaker and the
listening position.
• The distance changes by 0.1 meters (or 1 foot when the
unit is set to feet) each time the CURSOR
is pressed. Select the value closest to the measured
distance.
Make sure the difference in the distances set for the
various speakers is no greater than 4.5 meters (15 feet).
If an inappropriate distance is set, "CAUTION: INVALID
DISTANCE" is displayed. Change the position of the
speaker and make the setting over.
To set the distance of the various speakers back to their
default values, press the CURSOR
"DEFAULT" then press the ENTER button.
5
ª
button to select Press the
ENTER
button. MENU", then press the
• The "SPEAKER SETUP" screen appears.
6
Press the
SETUP MENU", then press the
the setting.
• The next screen in the "SETUP" menu screen appears.

Setting "SPEAKER LOCATION"

The optimum acoustics can be achieved by setting the location
of the speakers and the conditions in the room.
1
Press the
"SPEAKER SETUP" at the "AUDIO SETUP",
then press the
button.
• The "SPEAKER SETUP" screen appears.
ª button to select the
0 or 1 button
or button
0 0 1 1
or button to select
• ª
CURSOR ª
button to select "SETUP
ENTER
button.
CURSOR ª
button to select "NEXT
ENTER
to enter
CURSOR •
or ª button to select
ENTER
button.
49
ENGLISH
2
CURSOR •
Press the or ª
"SPEAKER LOCATION", then press the
ENTER
button.
• The speaker locations setting screen appears.
LOCATION:
Select the speaker setting location.
ROOM DAMPING:
Select the reverberation of the sound in the room in which the
speakers are located.
3
CURSOR
Press the 0 or 1 button to select "1",
"2" or "3" for the "LOCATION" mode, then
CURSOR ª
press the button.
• The "SPEAKER SETUP" screen appears.
1 (ON WALL):
Select this when satellite speakers are installed on the walls
or when there is a wall directly behind the speakers.
2 (ON SHELF) (Factory default):
Select this when the speakers are installed on a table or rack
using the included speaker stands.
3 (FREE STANDING):
Select this when a separately sold floor stand is installed.
Select "ON WALL" when there is a wall directly behind the
speakers, regardless of the "ON SHELF" or "FREE
STANDING" setting.
System Setup
button to select