Akai MPC User Manual page 349

Effects (Hardware): User Guide v1.7 did not have a description of the Effects window (shown in the
MPC hardware display only). The Send and Insert tabs have been moved from F4 and F5 to F1 and F2,
as well.
The explanation of the Effects in the software itself (and corrections due to updates in 1.8) is in
Send Effects (Page 232) and in
Hardware:
1. To open the Effects window, press Shift + Seq Edit / Effects.
2. To load or adjust send effects, press F1 (Send).
•
To load or adjust master insert effects, press F2 (Insert).
3. Use the Cursor Buttons to select the desired effect slot.
4. Use the Data Dial or –/+ buttons to open another page to select an effect. Press F4 (Select) to load
it, or press F3 (Back) to close the page.
5. Send effects only: To set the return level, use the Cursor Buttons to select the desired Level effect
slot. Use the Data Dial or –/+ buttons to set the level.
6. To make further adjustments to the effect parameters, select it, and then press Window to open its
parameter window or F6 (Edit).
The Send tab of the Effects window
in the MPC hardware display.
Appendix: Effects and Parameters: User Guide v1.7 previously had a few incorrect default parameter
values and Q-Link Knob numbers. These have been corrected in the
Parameters (Page 242).
Effects > Master Effects (Page
349
236).
The Insert tab of the Effects window
in the MPC hardware display.
Appendix > Effects and
Effects >