Program Insert Effects - Akai MPC User Manual

Program Insert Effects

You can apply, edit, or remove up to four Program insert effects. The instructions for doing this depend
on which mode you are in:
Mode, or Step Sequence
To load a Program insert effect in Main Mode or Step Sequence Mode:
1. In the software, click the Main Mode tab or Step Sequence tab in the Mode Tab
Section.
2. If the Insert button above the Program Channel strip (in the center of the lower
section) is not already selected, click it. Also, if the Inserts button is set to Off, click
it so it changes to On.
3. In one of the four Inserts slots of the Program Channel strip, click the downward
arrow ().
4. Select an effect from the menu that appears.
Hardware: To load a Program insert effect in Main Mode or Step Sequence Mode:
1. Enter Main Mode by pressing the Main button, or enter Step Sequence Mode by
pressing the Step Seq button.
2. Use the Cursor Buttons to select the Vel% field (the lower-right-most field), and
then press the Window button.
3. Use the Cursor Buttons to select one of the four Insert slots.
4. Use the Data Dial or the -/+ buttons to select an effect. Click F4 (Select) to load it,
or click F3 (Back) to close the page.
5. Press F4 (Close) when you are done.
Main Mode, Program Edit
Mode.
Mode, Program Mixer
229
Mode, Track Mixer