Furuno FCV-1900/B/G Installation Manual page 16

2. WIRING
If the monitor has a DVI-D port, a DVI-D cable is available optionally. For the monitor
unit MU-190/231/150HD, brilliance control is available, by connecting the USB cable
pictured below.
The following procedure shows how to connect the processor unit to the MU-190 mon-
itor unit.
1. Unfasten 14 binding screws to remove the cover.
2. Connect the A-TO-D ADAPTER cable (option) to HDMI port (J101) on the MAIN
board.
CN-3
NETWORK
MONITOR
NETWORK
USB
CN-4
Connection for MAIN board
3. Connect a USB cable (local supply) to the USB port (J105) on the MAIN board.
4. Unfasten the CN-3 seal nut at the top-right on the rear panel of the processor unit,
then pull out the gasket assembly.
USB A (M) connector
LAN cable
USB cable
MAIN 19P1084
USB
Super gland
Micro-B
(CN-4) (CN-3)
USB micro B (M)
connector
Monitor cable
J102 RJ-45
J105 ZX-62-AB-5PA
J101 CSS5319-4601F
Monitor
HDMI-D
Cable
clamp
J101
J105
9