Interface Unit - Furuno FCV-1900/B/G Installation Manual

4. Reconnect the WAGO connector.
5. Unfasten the cable clamp screws, then pass the cables through the cable clamp.
Fasten the screws to fix the cables with the cable clamp.
6. Fasten the connector cover to the chassis.
For connecting the TD-ID transducer, use the WAGO connectors on CN-7. Con-
nect each core to the terminal, referring to the instructions supplied with the TD-
ID transducer. For connection details, refer to the interconnection diagram at the
end of this manual.
2.2.4 Control unit
Connect the control unit's cable connector to the CN-5 connector on the processor
unit. For cable extension, the junction box RJB-002 (option) is available for 5 m length
addition. A ground terminal is attached under the unit. Connect an IV-1.25sq ground-
ing wire between the ground terminal on the control unit and the ship's ground.
2.2.5 External equipment
Use the optional cable with connector to connect the external equipment to the pro-
cessor unit.
For NMEA signal communication, the optional cable assembly MJ-A6SPF0003 is
used. Connect the cables to the processor unit via the CN-10 or CN-11 port. For con-
nection to the external equipment, see the equipment's installation manual.
Temperature sensor
Connect the sensor's cable with connector attached to connector CN-9.
Satellite compass
Connect the Satellite Compass
cable assembly MJ-A6SPF0003 and a junction box (local supply) are required. See
the interconnection diagram at the back of this manual.
External sounder or switch
Connect the external sounder to connector CN-8. An optional cable assembly MJ-
A7SPF0007 is required. To connect an external switch, see the interconnection dia-
gram at the back of this manual.
When the transmitter unit FN-6-2 is used, connect the plug and cable attached on the
unit to connector CN-8 directly.
2.3

Interface Unit

The interface unit FCV-1903 (option) is used to connect the FCV-1900 system to the
telesounder TS-7100 or TS-80M2. To connect the unit to the processor unit, use the
UL2464-SB/1062 cable assembly attached to the interface unit.
Note: The telesounder products are sold only in Japan.
1. Remove the cover from the interface unit. Remove the cover of the processor unit
also.
™
SC-30/50/110 to the connector CN-12. An optional
12
2. WIRING