Nmea Port Setting - Furuno FCV-1900/B/G Installation Manual

3. INITIAL SETTINGS
3.4

NMEA Port Setting

The [NMEA Port Set&Monitor] menu sets up the NMEA port and shows the data being
input/output from the NMEA ports.
Rotate the ENTER knob to select the port that you want to set up and push the knob
to open the [Setting] window.
$GPGNS,102716.01,8900.0413,N,17859.99
99,E,A,00,0.0,0.0,0.0,0.0,0.0,S*4F
NMEA 0183
$GPMTW,27.30,C*32
Output Data
$GPVHW,0.00,T359.94,M,8.10,N,,*1C
TLL Output
$GPVTG,359.95,T,359.95,M,6,6.48,N,,,A*7C
NMEA Port Setting
$GPZDA,102716.20,24,02,2015,00,00*65
Baud Rate
[Setting] window
Start Bit
Data Length
Stop Bit
Parity
Clear Window
Exit
[NMEA0183]: Select NMEA0183 version of navigation equipment connected to the
NMEA port (SC and CIF are not available). The choices are [Ver1.5], [Ver2.0], [Ver3.0]
and [Special]. [Special] is for use with a navigator whose baud rate is 600bps.
[Output Data]: Select the data to output from the NMEA port to navigation equipment
(SC and CIF are not available).
[TLL Output]: Select the TLL data type to output from the NMEA port to a chart plotter
(SC and CIF are not available).
[NMEA Port Setting]: Select the format for the communication port's data. The set-
tings are as follows.
• Baud Rate: 600/4800/38400 bps for NMEA and 600/1200/2400/4800 bps for CIF
• Start Bit: 1 bit (fixed)
• Data Length: 8 bit (fixed)
• Stop Bit: 1 bit (fixed)
• Parity: none (fixed)
[Clear Window]: Refresh the information on the communication port monitor display.
[Exit]: Close the [NMEA Port Set&Monitor] menu to return to the normal menu.
Port selection
NMEA1 Set up the CN-10 (NMEA1) port
NMEA2 Set up the CN-11 (NMEA2) port
SC Set up the CN-12 (NMEA3) port
CIF Set up the CN-6 (SONDE/TRIG) port
NMEA Port 1 Input
Setting
Ver1.5
TLL
600
1bit
8bit
1bit
none
NMEA Port 1 Output
$SDDBT,102.6,f,31.3,M,17.1,F*05
$SDDPT,31.3,0.0,200.0*66
SSDDBT,T102.6,f,31.3,M,17.1,F*05
$SDDPT,31.3,0.0,200.0*66
23
Communication port
monitor display
(see section 3.5)