Transducer Setting - Furuno FCV-1900/B/G Installation Manual

3.3

Transducer Setting

The menu tabs names listed below are for setting up external transducers. This allows
you to adjust the transducer settings from the FCV-1900.
• DFF1/DFF3/BBDS1 transducer
• Telesounder (products sold only in Japan)
Select the transducer
1. Referring to section 3.2, open the [Service] menu.
2. After you have selected [Service], the following message appears.
3. Select [Yes] and push the ENTER knob to turn the power off.
4. Press the power key to turn the power on.
The [XDCR Setting] menu appears.
5. Select [XDCR type] at [HF XDCR select].
Confirm that the high freq. transducer is connected to the HF port.
CAUTION
Set the transducer data properly.
Wrong data setting may damage the
transducer and void the warranty.
System will power down
automatically. Turn the
power on again, and
change the tarnsducer
setting.
Yes
Own XDCR Setting DFF1,DFF3,BBDS1 Transducer
HF XDCR Select
HF Connection
Freq
Transducer
Tx power
Voltage
Freq
Band width
TX mode
LF XDCR select
LF Connection
Freq
Transducer
Tx Power
Voltage
Freq
Band width
TX mode
Tankenmaru Connection
External Telesounder
Net Sonde
Save Setting
20
No
XDCR Type
Connected
200kHz
50/200-1T
1kW
120V
---kHz
---kHz
Std
XDCR Type
Connected
50kHz
50/200-1T
1kW
120V
---kHz
---kHz
Std
On
Off
Off
3. INITIAL SETTINGS