Hitachi PH Instruction Manual page 63

See Section 1.5.3-1,
"Ready output signal".
Entering a deflection
voltage ON/OFF
signal executes the
same action.
(See Section 1.5.3-9,
Input for remote
control signals.)
2-8 ● Startup
(2) Switching between "Ready" state and "Standby" state
● When the conveyer interlock is put in operation by the Ready output signal, be careful not
to switch to "Standby" state since it will stop the conveyer.
Switching from "Ready"
state to "Standby" state
Manual Control Menu
Manual Control Menu
No-cleaning stop : Stops ink ejection without cleaning.
Standby : Switches between the ready-for-printing state and standby state.
Online/ No-cleaning
Offline stop
Press the Standby key.
Print Abort Confirmation
Printing will be aborted.
Solution Press [OK] to abort.
OK
Press the OK key.
● You can abort the operation by pressing the Cancel key from either the "Manual Control
Menu" screen or the confirmation screen.
Com=0
Shut
Manual
down
《
Menu
2 The control menu appears.
Standby Cancel
3 The confirmation screen opens.
Cancel
1
Press the Manual key.
》
Switching from "Standby"
state to "Ready" state
Manual Control Menu
Manual Control Menu
No-cleaning stop : Stops ink ejection without cleaning.
Ready : Switches between the ready-for-printing state and standby state.
Online/
No-cleaning
Offline stop
Press the Ready key.
Print Confirmation
The newly created print data will be printed.
Solution Press [OK] to print..
OK
Press the OK key.
Cancel
Ready
Cancel