Hitachi PH Instruction Manual page 266

10. Emergency Procedures
● If an earthquake, fire, or other emergency arises while the
printer is making prints or otherwise energized, turn OFF the
power by pressing the power ON/OFF switch.
Never perform this procedure except in case of emergency.
● Immediately after the emergency is cleared, press the power ON/OFF switch to turn
the power back ON and press the Start up key to initiate ink ejection.
● If the emergency seems to persist for a period of 5 minutes or longer, open the print
head cover, and clean the orifice plate and its surrounding parts and gutter section by
pouring makeup ink over them.
When resuming an operation, thoroughly clean the orifice plate and its surrounding
parts and gutter section by pouring makeup ink over them, and then initiate ink
ejection.
● If the power supply is shut off by a power failure, perform the same procedure as
indicated above.
In the event of a power failure
When you use the printer after power restoration, be sure to
1
confirm the printings and other setup data beforehand. If you find
any incorrect printings or setup data, correct it.
2 Note that the count update information for printing is not saved in
memory.
When you use the printer after power restoration, it is necessary
to set the count update information (initial value data) again.
Press the power ON/OFF switch to turn OFF the power.
Press.
WARNING
CAUTION
● Emergency Procedures 10-1