Hitachi PH Instruction Manual page 235

7-23 ● Ink Filter Replacement
Remove the piping couplings (C and D), and replace it with a
9
new ink filter.
Piping (C)
Handle
Press the Start/Continue key.
10
● The following operating guidance appears on the display.
Circulation control
Process : Ink filter replacement
Operating guide
Change the direction of the ink filter so
that tube (D) is at the top of the filter.
Press [Start/Continue].
Proc.time: Approx. 4 minutes
Set the ink filter as follows (piping D is the upside).
11
Ink filter
Piping (D)
Piping (D)
CAUTION
Mount and remove the piping
1
couplings by rotating them by
hand instead of using a tool.
Be careful not to mistake the
2
piping mounting positions (C is
the center of the ink filter, and D is
the outside).
Piping (D)
A small amount of ink remains
3
within the ink filter. Watch out for
ink spillage when replacing it.
Status: Stop
Ink drainage
Filter rep.
Ink refill
Proc. status: In progress
Handle
Piping (C)
Com=0
Abort
Start/
Continue