Hitachi PH Instruction Manual page 183

6-22 ● Transmission Sequences
● Bar code "used"→ "not used"
ESC Header 29H
● Bar code "not used" → "used"
ESC Header 29H
● EAN readable code (EAN-13)
ESC Header 7DH
● Prefix code (EAN-13)
ESC Header 2CH
● Code set (Code128)
ESC Header 3FH
● Increased width
ESC Header 28H
● Two or more print format items can be consecutively transmitted in a single chain.
(4) If you do not specify the item number, the setup data applies to all
print items.
NOTE: When transmitting print format and print specification data
consecutively in a single chain, ensure that the print format data
precedes the print specifications data.
If this order is reversed, a communication error occurs.
6.4.4-2 Text setup rules
(1) Print format
a) Line count
● When you change the line count for a print item in a certain column, you must also
set the line count for the other print items that belong to the same column.
(Example)
1 3 5
2 4 6
Transmit the line count consecutively to items 7 and 8. If you transmit the line count
to only one of them, a communication error occurs.
● When you change the line count for a print item, you must also set the line count for
the other print items that belong to the same column as the former one.
(Example)
1 3 5
2 4 6
Transmit the line count consecutively to items 7 and 8. If you transmit the line
count to only one of them, a communication error occurs.
30H
Use (0: not used; 1: used)
31H ESC
Use (0: not used; 1: used)
Code
Code type (0: None 1: 5x5 2: 5x7)
Tens position Units position
Prefix code (00 to 99)
Code set
0: code set B; 1: code set C
Increased
width
Increased width (1to 9)
7
8
Setting items 7
and 8 to one line
7 8
Setting items 7
and 8 to two lines
Header 2AH Type
Bar code type (0 to 6)
1 3 5
2 4 6 7
1 3 5
2 4 6
8
7
8