Hitachi PH Instruction Manual page 244

Perform printing and check printing results.
6
In the case where the "Print trigger source" is "1: Button input", press
1
Start printing .
Incremental change
Excitation V-ref. is printed on the print target.
［■■ ｎ ｎ ・ ・ ・ ・ ・ ・ ］
Printing starts at the press of [Start printing].
2 In the case where the "Print trigger source" is "2: Sensor", input the
sensor signal.
● When printing, allow an interval from the previous printing.
Check the printing of the other excitation V-ref..
7
1 In the case where the "Automatic update" is "0: disable":
Press the Increment and Decrement keys to change the excitation V-ref..
Nozzle property test
Excitation V-ref.
Ref. ambient temperature 23 (
Automatic update
Incremental change
Excitation V-ref. is printed on the print target.
［■■ ｎ ｎ ・ ・ ・ ・ ・ ・ ］
Printing starts upon signal from sensor.
2 In the case where the "Automatic update" is "1: decrement":
The excitation V-ref. automatically decrements by 1 each time the
printing is performed.
[ex.] Number of printing times : 1st time → 2nd time → 3rd time
Excitation V-ref.
3 In the case where the "Automatic update" is "2: increment":
The excitation V-ref. automatically increases by 1 each time the printing
is performed.
[ex.] Number of printing times : 1st time →2nd time →3rd time
Excitation V-ref.
Check the range capable of good printing.
8
● The optimum set value is the center value in the good printing range.
● Summarize the printing results as in the following table, and check excitation
voltage capable of printing.
[ex.] Good printing range (5 to 15), optimum value (10)
Ambient
Date
temperature
0 1
15.07.07
22 ℃
[ 1 ] (1-9)
Status: Ready
[ 1 1 ] (0~19)
)
℃
disable
[ ] (0: 1:Decrement 2:Increment )
0
[ 1 ] (1-9)
: [11]
: [11]
Excitation V value
2 3 4 5 6 7 8
× × ×
Abort
Start
Decre-
printing
ment
Incre-
ment
Abort
Decre-
ment
Incre-
ment
→ [10] → [09]
→ [12] → [13]
9 10 11 12 13 14 15 16 17 18 19
×
● Excitation Setting Adjustment 7-32
× × ×