Hitachi PH Instruction Manual page 58

● If the ink jets out continuously, a fault exists.
Press the Manual key to display the control menu. Press the No-cleaning stop
and OK keys in sequence to stop the ink ejection operation.
No-cleaning stop : Stops ink ejection without cleaning.
Standby : Switches between the ready-for-printing state and standby state.
Online/
Offline
Shutdown will stop the ink jet.
Solution To stop the ink jet, press [OK].
● For the subsequent operations, see Section 2.1.2, If a fault occurs at the
beginning of an operation.
● When the ink jets out, it may momentarily scatter and stain paper.
However, this does not indicate any abnormality at all.
Wait until the status changes from "Starting" to "Ready."
3
● If any startup fault occurs, see Section 2.1.2, If a fault occurs at the beginning
of an operation.
● When the temperature is low (below 20
printer to become "Ready for printing" than at a normal temperature.
Input the print target detection signal and verify that the
4
printing state and printing contents are correct.
Com=0
Manual Shut
down
Press the Manual key.
《 》
Menu
Manual Control Menu
No-cleaning
Standby
stop
Press the No-cleaning stop key.
Shutdown Process Confirmation
Cancel
OK
Press the OK key.
or so), it takes slightly longer for the
℃
● When the print target detection
Print target
Manual Control Menu
Cancel
signal is entered while the
printer is "Ready," the
preselected print is made.
●Startup 2-3