ZyXEL Communications ZyWall USG20-VPN User Manual page 326

Figure 216 Configuration > Security Policy > Policy Control > Add
The following table describes the labels in this screen.
Table 127 Configuration > Security Policy > Policy Control > Add
LABEL DESCRIPTION
Create new Use to configure any new settings objects that you need to use in this screen.
Object
Enable Select this check box to activate the Security policy.
Name Type a name to identify the policy
Description Enter a descriptive name of up to 60 printable ASCII characters for the Policy. Spaces are
allowed.
From For through-USG policies, select the direction of travel of packets to which the policy applies.
To any means all interfaces.
Device means packets destined for the USG itself.
Source Select an IPv4 / IPv6 address or address group object to apply the policy to traffic coming
from it. Select any to apply the policy to all traffic coming from IPv4 / IPv6 addresses.
Destination Select an IPv4 / IPv6 address or address group to apply the policy to traffic going to it.
Select any to apply the policy to all traffic going to IPv4 / IPv6 addresses.
Service Select a service or service group from the drop-down list box.
User This field is not available when you are configuring a to-USG policy.
Select a user name or user group to which to apply the policy. The Security Policy is
activated only when the specified user logs into the system and the policy will be disabled
when the user logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified a source IP address (group) instead of any in the field below, the user's
Schedule Select a schedule that defines when the policy applies. Otherwise, select none and the
policy is always effective.
Chapter 20 Security Policy
IP address should be within the IP address range.
USG20(W)-VPN Series User's Guide
326