Configuring The Ospf Screen - ZyXEL Communications ZyWall USG20-VPN User Manual

OSPF Configuration
Follow these steps when you configure OSPF on the USG.
Enable OSPF.
1
Set up the OSPF areas.
2
Configure the appropriate interfaces. See
3
Set up virtual links, as needed.
4

10.7.1 Configuring the OSPF Screen

Use the first OSPF screen to specify the OSPF router the USG uses in the OSPF AS and maintain the
policies for redistribution. In addition, it provides a summary of OSPF areas, allows you to remove
them, and opens the OSPF Add/Edit screen to add or edit them.
Click Configuration > Network > Routing > OSPF to open the following screen.
Figure 161 Configuration > Network > Routing > OSPF
The following table describes the labels in this screen. See
information as well.
Table 98 Configuration > Network > Routing Protocol > OSPF
LABEL
OSPF Router ID
Redistribute
Active RIP
Chapter 10 Routing
Section 9.3.1 on page
DESCRIPTION
Select the 32-bit ID the USG uses in the OSPF AS.
Default - the first available interface IP address is the USG's ID.
User Defined - enter the ID (in IP address format) in the field that appears when
you select User Define.
Select this to advertise routes that were learned from RIP. The USG advertises
routes learned from RIP to Normal and NSSA areas but not to Stub areas.
USG20(W)-VPN Series User's Guide
244
149.
Section 10.7.2 on page 245 for more