Ethernet Neighbor Screen - ZyXEL Communications ZyWall USG20-VPN User Manual

Table 44 Monitor > System Status > USB Storage (continued)
LABEL
Status
Detail

6.13 Ethernet Neighbor Screen

The Ethernet Neighbor screen allows you to view the USG's neighboring devices in one place.
It uses Smart Connect, that is Link Layer Discovery Protocol (LLDP) for discovering and configuring
LLDP-aware devices in the same broadcast domain as the USG that you're logged into using the
web configurator.
LLDP is a layer-2 protocol that allows a network device to advertise its identity and capabilities on
the local network. It also allows the device to maintain and store information from adjacent devices
which are directly connected to the network device. This helps you discover network changes and
perform necessary network reconfiguration and management.
Note: Enable Smart Connect in the System > ZON screen.
See also System > ZON for more information on the ZyXEL One Network (ZON) utility that uses
the ZyXEL Discovery Protocol (ZDP) for discovering and configuring ZDP-aware ZyXEL devices in
the same network as the computer on which the ZON utility is installed.
Click Monitor > System Status > Ethernet Neighbor to see the following screen
Figure 99 Monitor > System Status > Ethernet Neighbor
Chapter 6 Monitor
DESCRIPTION
Ready - you can have the USG use the USB storage device.
Click Remove Now to stop the USG from using the USB storage device so you can
remove it.
Unused - the connected USB storage device was manually unmounted by using
the Remove Now button or for some reason the USG cannot mount it.
Click Use It to have the USG mount a connected USB storage device. This button
is grayed out if the file system is not supported (unknown) by the USG.
none - no USB storage device is connected.
This field displays any other information the USG retrieves from the USB storage
device.
• Deactivated - the use of a USB storage device is disabled (turned off) on the
USG.
• OutofSpace - the available disk space is less than the disk space full threshold.
• Mounting - the USG is mounting the USB storage device.
• Removing - the USG is unmounting the USB storage device.
• none - the USB device is operating normally or not connected.
USG20(W)-VPN Series User's Guide
117