Dishes; Information On The Settings; Baking Sensor; Selecting And Setting Food - Siemens HN678G4.1 Instruction Manual

PDishes
You can use the "Dishes" operating mode to prepare a
D i s h e s
wide variety of food. The appliance chooses the optimal
setting for you.

Information on the settings

The cooking result depends on the quality of the
■
food and the size and type of cookware. For an
optimal cooking result, use food that is in good
condition and chilled meat only. For frozen food, use
food straight out of the freezer only.
For some food, a temperature, heating mode and
■
cooking time is suggested. The temperature and the
cooking time can be changed according to your
requirements.
For other dishes, you will be asked to enter the
■
weight. Always enter the total weight unless the
appliance asks for something different. The
appliance will then apply the time and temperature
settings for you.
It is not possible to set weights outside of the
intended weight range.
When roasting dishes for which the appliance will
■
apply the temperature selection for you,
temperatures of up to 300 °C can be saved.
Therefore, make sure that you use cookware that is
sufficiently heat resistant.
Information is provided, e.g. on cookware, shelf
■
position or the addition of liquid when cooking meat.
Some food requires turning or stirring, etc., during
cooking. This is shown in the display shortly after
operation starts. An audible signal will remind you at
the right time.
Information on the right kind of cookware to use and
■
tips and tricks for the preparation can be found at
the end of the instruction manual. ~ "Tested for you
in our cooking studio" on page 36
Microwave
For some food, the microwave is automatically
activated. Using the microwave significantly reduces
cooking time – cooking time is virtually cut in half. The
appliance instructs you to use cookware that is suitable
for the microwave. The "Microwave" section provides
information on the type of cookware that is suitable.
~ "Microwave" on page 20
Meat thermometer
For some food, you can also use the meat
thermometer. Once you have inserted the meat
thermometer into the appliance, the food that is suitable
for it will be displayed. You can change the interior
temperature of the cooking compartment and the core
temperature. ~ "Meat thermometer" on page 24

Baking sensor

Your appliance is equipped with a baking sensor. This
sensor is automatically activated when you select a
corresponding baked item from the selection list. The
appliance now takes over. The appliance switches off
once the baked item is cooked. An audible signal
sounds. The cooking time is approximately that listed in
the recipe for your baked item and is not displayed.
Do not use any silicone bakeware or accessories that
contain silicone. Otherwise, the baking sensor will be
damaged.
You must not open the appliance door whilst "Baking
sensor active" is shown on the display. Otherwise, the
settings will be cancelled. In this case, the appliance will
provide you with a setting that you must monitor
yourself.

Selecting and setting food

Press the menu button.
1.
The operating modes menu opens.
Select the "Dishes" operating mode.
2.
The first program group appears on the display.
Use the rotary selector to select the required
3.
program group.
Touch the "Next" field.
4.
Use the rotary selector to select the food.
5.
You will be guided through the entire setting process for
your chosen food. Always touch the "Next" field.
Once you have implemented all the settings, start by
pressing the "Start/stop" button.
The appliance informs you if the cooking
Note:
compartment is still too hot for your chosen food.
The program has ended
An audible signal sounds. "Finished" appears in the
status bar. The oven stops heating. You can cancel the
audible signal early using the
If you are not satisfied with the cooking result, you can
increase the cooking time again. Touch the "Extend
cooking time" field. A cooking time is suggested.
However, you can change this if you wish.
If you are satisfied with the cooking result, touch
"Finish". "Enjoy your meal" appears on the display.
Cancelling the program
Press the "On/off" button. All settings are deleted. You
can implement new settings.
Setting a later end time
For some dishes, it is possible to set a later end time.
Refer to the time-setting options. ~ "Time-setting
options" on page 17
Once you have set an end time, the display shows the
waiting time. The status bar shows the time at which
operation is to start. None of the settings can be
changed. Please remember that easily spoiled foods
must not be allowed to remain in the cooking
compartment for too long.
Dishes en
0 button.
35