Descaling - Siemens HN678G4.1 Instruction Manual

Cleaning function
en
status bar. The interior lighting remains off during
cleaning.
:
Warning
Risk of burns!
The cooking compartment becomes extremely hot
■
during the cleaning function. Never open the
appliance door or move the locking latch by hand.
Allow the appliance to cool down. Keep children
away from the appliance.
The appliance will become very hot on the
;
Risk of burns!
■
outside during the cleaning function. Never touch the
appliance door. Allow the appliance to cool down.
Keep children away from the appliance.
Prior to initiating the cleaning function
Caution!
Before cleaning is started, remove the water tank from
the appliance. ~ "Steam" on page 21
When using the cleaning function, you can clean an
accessory at the same time, e.g. the universal pan or
the baking tray. Before cleaning is started, remove the
worst dirt. Slide the accessory in at level 2.
Clean the inside of the appliance door and along the
surface edges of the cooking compartment in the area
around the seal. Do not scrub the seal.
When using the cleaning function, you can clean
Note:
the enamel accessory provided at the same time. You
cannot clean any of the wire racks when using the
cleaning function. The wire racks are not suitable for
cleaning using the cleaning function; this will discolour
them. Further accessories suitable for cleaning using
the cleaning function are listed in the table for special
accessories. ~ "Accessories" on page 13
:
Warning
Risk of fire!
Loose food residues, grease and meat juices may
■
catch fire during the cleaning function. Before
starting the cleaning function, remove coarse dirt
from the cooking compartment and from the
accessories.
The appliance will become very hot on the outside
Risk of fire!
■
during the cleaning function. Never hang
combustible objects, e.g. tea towels, on the door
handle. Do not place anything against the front of
the appliance. Keep children away from the
appliance.
:
Warning
Risk of serious damage to health!
The appliance will become very hot during the cleaning
function. The non-stick coating on baking trays and tins
is destroyed and noxious gases are released. Never
clean non-stick baking trays and baking tins using the
cleaning function. Only clean enamelled accessories
using the cleaning function.
Setting the self-cleaning function
Press the menu button.
1.
The operating modes menu opens.
28
Select the "Self-cleaning" operating mode.
2.
Cleaning setting 3 is suggested. You can start the
cleaning process immediately using the "Start/stop"
button or
select a different cleaning setting using the rotary
3.
selector.
Press the "Start/stop" button to start the cleaning
4.
operation.
The cooking compartment door locks shortly after
operation starts. The symbol for the locking
H
mechanism appears on the right-hand side of the status
bar next to the elapsing duration.
The cooking compartment door cannot be opened until
the symbol goes out in the status bar.
H
Once the cleaning has finished
An audible signal sounds. The oven stops heating.
"Finished" appears in the status bar. Use the
to switch off the audible signal. "Appliance cooling
down" appears in the status bar.
Cancelling the cleaning operation
Use the "On/off" button to switch off the oven. The
cooking compartment door cannot be opened until the
symbol goes out in the status bar.
H
Adjusting the cleaning setting
Once cleaning starts, the cleaning setting can no longer
be changed.
You can set the cleaning to run overnight
In the section "Time settings", you can find out how to
delay the end time. This allows you to use the oven at
any time throughout the day. ~ "Time-setting options"
on page 17
Once the cleaning function has ended
Once the cooking compartment has cooled down, wipe
off the ash that has been left behind in the cooking
compartment, in the accessories, on the shelves and
around the appliance door with a damp cloth.
After cleaning, the rails may retain some discolouration.
This does not affect their operation. Wipe the rails with a
damp cloth. Then slide the rails in and out several
times.
During cleaning, the frame on the inside of the
appliance door may discolour. This is normal and does
not affect operation. The discolouration can only be
removed using a stainless-steel cleaning agent.

Descaling

The appliance must be descaled regularly in order for it
to continue operating correctly.
There are several steps in the descaling programme.
For hygiene reasons, the descaling programme must
be run through completely so that the appliance can be
ready for operation again.In total, the descaling
programme runs for approx. 70-90 minutes.
Descale (approx. 55-70 minutes), then empty and
■
refill the water tank
button
0