After Every Steam Operation - Siemens HN678G4.1 Instruction Manual

If you use mineral water, you must only use non-
■
carbonated mineral water.
Touch the X field.
1.
The control panel is automatically pushed forwards.
Pull the control panel forwards with both hands and
2.
then push it upwards until it locks into place (Fig.
Lift the water tank and remove it from the water tank
3.
recess (Fig. ).
"
Fill the water tank with cold water up to the "max."
4.
mark (Fig. ).
#
Insert the filled water tank (Fig.
5.
water tank locks into place behind both holders
(Fig. ).
%
Slowly push the control panel downwards and then
6.
towards the rear until it is closed completely.
The water tank has been filled. You can start
operations with steam.
Refilling the water tank
If the water tank runs dry during a steam operation, a
message appears on the display prompting you to fill
up the water tank.
Notes
Steam-assisted operations continue without adding
■
steam.
If the water tank runs dry during the operation with
■
the Dough proving or Reheating setting, the
operation is interrupted. Fill the water tank.
).
!
). Ensure that the
$
‚
Open the control panel.
1.
Remove and refill the water tank.
2.
Insert the filled water tank and close the control
3.
panel.

After every steam operation

:
Warning
Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
:
Warning
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
Caution!
Enamel damage: Do not start any operations when
there is water on the cooking compartment floor. Before
operation, wipe away the water from the cooking
compartment floor.
The remaining water is pumped back into the water
tank after every operation with steam. Then empty and
dry the water tank. Moisture remains in the cooking
compartment. To dry the cooking compartment, you
can either use the "Drying function" operating mode or
dry the cooking compartment by hand.
Notes
Once the appliance has been switched off, the
■
field remains lit for a little longer to remind you to
empty the water tank.
Remove limescale marks with a cloth soaked in
■
vinegar, then wipe with clean water and dry with a
soft cloth.
Emptying the water tank
Caution!
Do not dry the water tank in the hot cooking
compartment. This will damage the water tank.
Caution!
Do not clean the water tank in the dishwasher. This will
damage the water tank.
Open the control panel.
1.
Remove the water tank.
2.
Carefully remove the lid of the water tank.
3.
Empty and rinse the water tank.
4.
Dry all parts with a soft cloth.
5.
Place the lid on the water tank and push it down.
6.
Insert the water tank and close the control panel.
7.
Starting the Drying function
During drying, the cooking compartment is heated up
so that the moisture in the cooking compartment
evaporates. Then open the appliance door so that the
steam escapes.
Steam en
X
23