Table of Contents
Advertisement
EHN3200
6. Check "Enable Pre-Trigger Buffer" and "Enable Post-Trigger Buffer".
7. Click
to save this event in event list.
Pre/Post Trigger Settings
This function is used to be able to review what happened immediately before and
after a trigger, e.g. 5 seconds before or after a motion has been detected, or after
motion detection ceases.
Pre-Trigger Buffer: Image saved internally in the camera from the time
immediately preceding the trigger. Input the desired length of pre-trigger buffer
time. It can be set up to 120 seconds.
Post-Trigger Buffer: Image saved internally in the camera from the time
immediately after the trigger condition has ceased/been reset. Input the desired
length of post-trigger buffer time. It can be set up to 120 seconds.
Press Apply to apply the setting changes or Reset to reset without saving the
change.
5.7.2 Motion Detection
Motion Detection
User can define the motion areas to be detected by clicking on 2 points
38
Advertisement
Table of Contents
