Motion Detection - EverFocus ENQ2200 User Manual

All manuals and user guides at all-guides.com

5.7.2 Motion Detection

Motion Detection
Users can define the motion areas to be de
the start point. Then click the mouse again at the end point, a rectangle will be
formed as the motion detection area.
Press Update Image to update the current image.
Pres s Select All to have the entire screen selected for motion detection.
Press Clear All and click on the rectangle, to clear that rectangle.
Press Era ser and click on the selected rectangle to remove
T here are 4 possible motion trigger areas, which can be dist
d ifferent c olors. Check the Enable checkbox to enable event actions related to that
a rea.
F or each area, you can set the event action in response to motion detection in that
area. Event actions can be set in "Event List" section.
In additio n, you can set the Sensitivity level for the motion trigger separately for
each area by selecting from 1 (low), 2, 3, 4, 5, 6, 7, 8, 9 to 10 (high).
Press Apply to apply the setting changes or Reset to reset without saving the
change.
tected by left clicking the mouse to set
the selection.
inguished by 4
32
EQN2200/2201