Table of Contents
Advertisement
The following information is required to configure the network settings. Contact
the network administrator or your Internet service provider.
IP Settings
• IP Type
• IP address
• Subnet mask
• Gateway (when using the gateway server/router)
• Primary DNS, Secondary DNS (when using DNS)
IP Type
DHCP: Configure the DHCP server not to assign the same IP addresses used for
the other network cameras and PCs whose IP address is unique.
Refer to the network administrator for the settings of the server.
Default: DHCP.
Note: If a DHCP server is not available, the system will use xxx.xxx.xxx.xxx as the
default IP address.
Static IP: User can manually set the static IP for network connection.
PPPoE: This is for a DSL DIRECT connection application; the ISP will require a
user name and password. (That is, if a single camera is connected directly to the
DSL modem.)
Note: If PPPoE is used as IP type, IP Utility software will not be able to detect the
device.
IP address
When not using DHCP, enter the IP address of the camera. Avoid address conflicts;
do not enter an IP address already used for a PC or other network cameras. Every
device on an IP network must have a unique IP address.
Subnet Mask
This field is to set the netmask for your network so as the IP camera will be
recognized within the network. Example: 255.255.255.000 typical for a Class "C"
network. When DHCP is selected, the DHCP server will assign this value
automatically.
18
EHN3200
Advertisement
Table of Contents
