Scene Select Setting; Using The Scene Select Setting Menu - Panasonic WV-CS950 Operating Instructions Manual

WV-CS950_US 05.4.27 8:54 PM ページ40

SCENE SELECT SETTING

■ Using the Scene Select Setting
Menu
Display the scene select setting menu from the setup
menu to configure scene select settings. First, display
the scene select setting menu.
1. Display the setup menu (page 21), move the cursor
to SCENE SELECT O, and then press the CAM
(SET) button.
This will display the scene select setting menu.
**SCENE SELECT**
SCENE
LOAD
RET TOP
● Scene Select Settings
Use the following procedure to configure scene select
settings.
1. Move the cursor to SCENE, and then tilt the joystick
left or right to change the scene setup.
INDOOR (L)
INDOOR (H)
OUTDOOR (L)
OUTDOOR (H)
Note: The camera cannot be installed outside.
Settings related to the picture switch depending on
the scene settings. Scene select settings and
relationship to other settings are shown in the table
below.
INDOOR (L)
INDOOR (H)
OUTDOOR (L)
OUTDOOR (H) HIGH
2. Move the cursor to LOAD, and then press the CAM
(SET) button.
This will cause the setup you selected for SCENE in
step 1 to be applied to the image.
INDOOR(L)
: Indoor setting (picture quality
priority)
: Indoor setting (sensitivity
priority)
: Outdoor setting (picture
quality priority)
: Outdoor setting (sensitivity
priority)
AGC SENS UP SHUTTER
MID OFF OFF
×2 AUTO
HIGH OFF
MID OFF AUTO
×2 AUTO
AUTO
BW DNR WHITE BAL
OFF LOW ATW1
OFF HIGH ATW1
AUTO LOW ATW2
AUTO HIGH ATW2
-40-