Using The Scene Select Setting Menu - Panasonic WV-CZ392E: WV-CZ492E Operating Instructions Manual

Baud Rate
Specifies the transmission speed ("2400",
"4800", "9600", "19200" bit per second) for
the RS485 communication.
Default setting: 19200
Data Bit
Specifies the number of data bits ("7" or
"8" bits) for the RS485 communication.
Default setting: 8
Parity Check
Specifies the parity check mode ("NONE",
"ODD", "EVEN").
Default setting: NONE
Stop Bit
Specifies the number of stop bits ("1" or "2" bits).
Default setting: 1
X ON/X OFF
Specifies whether to apply flow control or
not ("USE" or "NOT USE").
Default setting: NOT USE
Wait Time
Specifies the time to wait until retrying
after confirming that no data is received
from the controller.
(OFF: no retry, 100, 200, 400, 1000 ms).
OFF 100MS
1000MS
Default setting: OFF
Alarm Data
Specifies the alarm transmission mode.
POLLING: Transmits the alarm data in response
to requests from the controller.
AUTO1: Transmits the alarm data each
time an alarm signal is received
by the camera.
AUTO2: Transmits alarm data at intervals
of 5 seconds.
Default setting: AUTO2
Delay Time
Specifies the time to transmit the acknowledge
request when communicating on a 2-line
connection.
OFF 100MS
34
200MS
400MS
This menu appears only when a 2-line
communication is used. Make sure to
be 100 ms when connecting the camera
with the Video Multiplexer WJ-SF616 or
the Matrix Switcher WJ-SX350 in a 2-line
communication system.
RS485 settings become effective with the
closing of setup menu.
Note:
• Set the same parameters for the cameras,
controllers and personal computers in an
RS485 chain.
 Using the scene select setting
menu
Display the scene select setting menu from the
setup menu to configure scene select settings.
First, display the scene select setting menu.
1. Display the setup menu (page 21), move
the cursor to "SCENE SELECT", and then
press the [SET] button.
This will display the scene select setting menu.
SCENE SELECT
**
SCENE
LOAD
RET TOP
•
Scene Select Settings
Use the following procedure to configure
scene select settings.
1. Move the cursor to "SCENE", and press the [LEFT]
or [RIGHT] button to change the scene setup.
INDOOR (L): Indoor setting (picture
quality priority)
INDOOR (H): Indoor setting (sensitivity
priority)
OUTDOOR (L): Outdoor setting (picture
quality priority)
OUTDOOR (H): Outdoor setting
(sensitivity priority)
Default setting: INDOOR (L)
Settings related to the picture switch
depending on the scene settings.
Scene select settings and relationship to
other settings are shown in the table below.
**
INDOOR (L)