Setting Of Scene Change Detection; Setting Of Detection Areas - Panasonic WV-CP500L Operating Instructions Manual

Setting of scene change detection

A change in a subject can be detected, e.g. covering the camera with a cloth, a cap, or others, or notably changing the camera direc-
tion.
Follow the procedure below.
"CAMERA SETUP" screen
**CAMERA SETUP**
SCENE1
ALC/ELC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW
1
DNR HIGH
BW MODE OFF
VMD
RET TOP END
Step1
Move the cursor to "VMD" and press the setting button.
→ The "VMD SETUP" screen appears.
Step2
Move the cursor to "SCENE CHANGE" and perform the setting.
ON: Provides an alarm signal when interference is detected.
OFF (default): Disables interference detection.

Setting of detection areas

The detection areas for motion detection and the detection of appearance/disappearance of stationary objects are specified. Up to 2
detection areas can be set.
Follow the procedure below.
"VMD SETUP" screen
**VMD SETUP**
MOTION DET ON
AREA SETUP
SENSITIVITY LOW
DISPLAY MODE
SCENE CHANGE OFF
RET TOP END
Step1
Move the cursor to "AREA" and select "SETUP", and then press the setting button.
→ The "AREA" screen appears.
Step2
Move the cursor to the number at the right of the title and select the area number using the right or left button.
Step3
Move the cursor to "POSITION" and press the setting button.
16
"VMD SETUP" screen
**VMD SETUP**
MOTION DET OFF
SCENE CHANGE OFF
RET TOP END
Area setting screen
**AREA 1 /2**(1)
POSITION PUSH SW
UPPER LEFT
DEL
RET TOP END