Resetting The Dome To Factory Default Settings Using The Reset/Reboot Switch - American Dynamics ADCI625-P221 Configuration And User's Manual

Networking Menu
Resetting the Dome to Factory Default Settings using the
Reset/Reboot Switch
The reset/reboot switch can be used to restore the dome to the factory default settings.
Note
It is not possible to retain network settings, presets, patterns or sequences when using this
procedure. If you need to maintain these settings it is recommended to reset the dome using the
GUI, refer to Procedure 7-21 Resetting the dome.
Procedure 7-23 Reset the Dome to Factory Default Settings using the
Reset/Reboot Switch
Step Action
Locate the reset/reboot switch on the dome.
1
Refer to Figure 7-2 Reset/Reboot Switch on the Dome.
Press and hold the reset/reboot switch for 15 seconds or longer.
2
Release the reset switch.
3
It may take up to 10 seconds for dome to restart. 

When the dome is restarted it checks its functionality by performing a homing routine
during which the camera pans and then either goes to the start point of the 'apple peel'
pattern or if powered up once before, to the last position in memory. Once the camera
stops, it is online and ready to be accessed and controlled.
7-94
- End -
Configuration and User Guide