ADC780 Series Indoor/Outdoor
Vandal-Resistant Cameras
Installation and Setup Guide
Corner Mount
Surface Mount
The ADC780 series camera is for use in areas
subject to vandalism such as subway stations,
parking garages, prisons, police stations, corridors,
supermarkets, and elevators. This camera, which
comes in NTSC and PAL versions:
Is contained in a cast aluminum housing with a
•
polycarbonate window or dome. Three versions
are offered: corner, flush, or surface mount.
Has 480 lines of resolution to produce a sharp
•
picture with true color and has a 2.6–6mm
variable focal auto iris lens.
Is protected by tamper-resistant hardware.
•
Meets weather resistance standards:
•
− Surface Mount: NEMA 4, IP43
− Corner Mount: NEMA 3R, IP43
− Flush Mount: NEMA 1, IP40.
Outdoor Applications
Except when used in the flush mount, the camera
can be mounted outdoors using an optional heater
and thermostat that maintains the operating
temperature between –40°C to +50°C.
© 2005 Sensormatic Electronics Corp.
ADC780 SERIES VANDAL-RESISTANT CAMERA
INSTALLATION AND SETUP GUIDE
Flush Mount
1 of 11
Features
Adjustable camera mount
•
Indoor/Outdoor installation (except flush mount)
•
¾- and ½-inch conduit holes
•
24Vac hookup
•
2.6–6mm variable focal color camera with dc
•
auto-iris adjustment
Parts Supplied
Caution: Installation should be performed by
qualified service personnel and in accordance with
all local and federal electrical and building codes.
Housing and associated hardware
•
Mounting screws (4)
•
Anchors, plastic (4)
•
Screws, M6x35 (4)
•
Washers, metal (4)
•
O-rings, rubber (4)
•
Desiccant (for corner mount, surface mount)
•
Mounting Plate (for flush mount, surface mount)
•
Screws, M4 x 8 pan head (4) – flush and
•
surface mounts only (for connection to electrical
box mounting plate)
Parts not Supplied
Teflon
plumbers tape
•
®
UL-listed electrical tape
•
Silicone caulk
•
(for corner and surface mounts only)
Threaded conduit
•
IMPORTANT! Threaded rigid type conduit must
be used for the corner and surface mount
versions.
Tools Required
Torx wrench
•
Small Phillips screwdriver
•
Small slotted screwdriver
•
8000-2811-01, REV. C1