How To Start A Sol Connection - IBM x3850 X6 Planning And Implementation Manual

/etc/inittab
Add the parameter that is highlighted in bold at the end of the /etc/inittab file, as shown in
Example 7-11.
Example 7-11 The /etc/inittab file
id:3:initdefault:
co:2345:respawn:/sbin/agetty ttyS1 115200 vt100-nav
[root@localhost etc]#

7.9.3 How to start a SoL connection

In this section, we explain how to connect to X6 through SoL.
Connecting to the X6 server with SoL
You can use Telnet or SSH to connect to the your X6 server. Follow these steps:
1. Start a Telnet/SSH session to the IMM2 IP address.
2. Log in to the IMM2. The default user id is USERID and the default password is PASSW0RD,
where the 0 is a zero.
3. The IMM CLI main page appears as seen Figure 7-34.
Figure 7-34 IMM CLI main page
4. Start SoL with the console 1 command.
5. The SoL console starts and you see whatever is transmitted over the SoL connection
(for example, the UEFI setup windows).
For additional information about using SoL commands, see the following website:
http://www.ibm.com/support/entry/portal/docdisplay?Indocid=MIGR-5086346
Chapter 7. Management
233