IBM x3850 X6 Planning And Implementation Manual page 196

Integrated Management Module (IMM)
You can perform certain firmware updates using the IMM. See 7.2, "Integrated Management
Module II (IMM2)" on page 201 for information about how to connect to the IMM. The IMM2
will allow you to update DSA, IMM2 (primary and backup images), and UEFI (primary and
backup images).
Note: Updating server firmware via the IMM2 is intended for recovery purposes. The
preferred method of updating firmware is to use IBM UpdateXpress System Pack Installer,
as outlined in this section.
The following section describes the process of updating the IMM2, UEFI, and DSA via the
IMM2 page:
1. From the IMM2 web interface, select Server Management  Server Firmware, as seen
in Figure 5-73.
Figure 5-73 The IMM2 Server Firmware panel
2. Click Update Firmware. A wizard will launch to guide you through the update process as
seen in Figure 5-74.
Figure 5-74 IMM2 firmware selection page
3. Ensure that you have downloaded the appropriate firmware update from the IBM support
page.
4. After you have selected your file, you can perform the firmware flash.
180
IBM System x3850 X6 and x3950 X6 Planning and Implementation Guide