Polaris 2014 RZR XP 1000 Service Manual page 86

10. Remove the outer clutch cover screws (Item 2) and
remove the cover from the vehicle.
11. Remove drive belt, drive clutch, driven clutch, inner
clutch cover and clutch outlet duct (see Chapter 6).
CAUTION
Correct Drive Clutch Puller P/N 2872085
NOTE: Be sure to use the correct Drive Clutch
Puller (PN 2872085) to prevent damage to
crankshaft.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
12. Disconnect the TMAP sensor (Item 3), fuel injector
harness leads (Item 4), CPS (Item 5), ECT sensor
(Item 6), and ignition coil harness lead. Remove wire
ties retaining harness to the fuel rail and rear cross
member.
13. Disconnect the stator harness.
14. Remove (+) positive cable from the starter motor.
15. Remove (-) negative cable from the starter mounting
bolt.
16. Disconnect fuel lines and remove throttle body
assembly (See Fuel Line Removal / Installation,
page 4.10 Fuel Line Removal / Installation, page
4.10 Throttle Body Removal, page 4.31). Make note
of line routing for installation.
17. Remove spark plug wires from the engine.
NOTE: The spark plug wires are marked with
MAG and PTO. Note
procedure.
18. Remove the breather hose (Item 7) from the
crankcase.
ENGINE
3
during installation
3.25