Polaris 2014 RZR XP 1000 Service Manual page 275

CLUTCHING
2. Install handle end of the Piston Pin Puller (PN
2870386) securely into bench vise and lightly grease
puller threads.
Piston Pin Puller: PN 2870386
3. Remove nut from puller rod and set aside.
4. Install puller adapter (Item 10) from kit PN 2871226.
5. Install main adapter (Item D) onto puller.
6. With towers pointing toward the vise, slide sheave
onto puller rod.
7. Install removal tool (Item A, B) into center of sheave
with "A side" toward sheave.
NOTE: Use Bushing Tool PA-47336.
8. Install nut (C) onto end of puller rod and hand
tighten. Turn puller barrel to increase tension on
sheave if needed. Using a hand held propane torch,
apply heat around outside of bushing until tiny
smoke tailings appear.
9. Turn sheave counterclockwise on puller rod until it
comes free. Lift sheave off puller.
10. Remove nut from puller rod and set aside.
6.18
11. Pull bushing removal tool and adapter from puller
rod. Remove bushing from tool and discard.
Moveable Sheave - Bushing Installation
12. Place main adapter (Item 8) on puller.
13. Apply Loctite® 648 evenly to bushing bore inside
moveable sheave.
14. Set bushing in place on sheave.
15. Insert installation puller tool (Item A/B) with "A" side
down, into center of bushing.
16. With towers pointing upward, slide sheave, bushing
and tool onto puller rod.
17. Install nut on puller rod and hand tighten. Turn barrel
to apply additional tension if needed.
18. Turn sheave counterclockwise, making sure bushing
is drawn straight into bore. Continue until bushing is
seated.
19. Remove nut from puller rod and set aside.
20. Remove sheave from puller.
21. Remove installation tool.
Cover Bushing Removal
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.