Polaris 2014 RZR XP 1000 Service Manual page 278

8. Tighten the spider jamb nut using Clutch Spider Nut
Socket (PU-50578). Torque jam nut to specification.
Spider Jamb Nut:
250 ft-lb (339 Nm)
(Apply 0.1 mL Loctite® 7088 Primer and 0.1 mL
Loctite® 620™) in 90° apart to the threads of the
spider jamb nut.
9. After the spider and jamb nut have been torqued,
remove the clutch assembly from the holding fixture
and inspect the alignment marks made during
disassembly.
NOTE: If the marks illustrated below are not in
alignment upon assembly, the clutch will not be
in balance and the drive clutch assembly must
be replaced.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
10. Install the limiter spacer (Item 15) and the clutch
spring (Item 14).
CAUTION
DO NOT reassemble the drive clutch without the limiter
spacer. Belt life will be greatly reduced.
11. Install the drive clutch cover (Item 16). Be sure all
alignment marts are in alignment.
12. Install cover bolts and torque in a cross pattern
evenly to specification.
Drive Clutch Cover Bolts:
9 ft-lb (12 Nm)
CLUTCHING
6
6.21