Polaris 2014 RZR XP 1000 Service Manual page 300

6. Align the front and rear prop shafts as shown below
and slide them together.
NOTE: Paint marks are applied to the front and
rear prop shafts to
Reference these marks during installation if still
visible.
7. Torque the support
specification.
Support Bearing Fasteners:
35 ft-lb (47 Nm)
aid shaft alignment.
bearing fasteners to
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
8. Align the front propshaft paint mark with the front
gearcase input shaft mark so the pin holes align.
Install a new roll pin.
FINAL DRIVE
7
7.11