Polaris 2014 RZR XP 1000 Service Manual page 338

4. Install M10 bolt and nut securing the transmission
bracket to the rear mount. Torque fasteners to
specification.
Rear Transmission Isolator Fasteners (Item 2):
40 ft-lb (54 Nm)
5. Install the two rear exhaust springs securing the
muffler to the rear transmission mounting bracket.
6. Install the Clutch Center Distance Tool (PU-50658)
onto the crankshaft and transmission input shaft to
properly position the clutch center distance.
IMPORTANT: Tool should bottom out on the
transmission input shaft and lay flush on the
crankshaft.
7. Loosen the two bolts retaining the transmission
coupler bracket to the engine on the right side.
8. Align front transmission mounting holes with
transmission joint bracket mounting holes on engine.
9. Loosely install the two longer bolts into left side
mounting holes and two shorter bolts with washers
into right side mounting holes.
NOTE: DO NOT torque fasteners at this time.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
TRANSMISSION
10. Torque left side mounting bolts to specification in
sequence.
11. Torque right side mounting bolts to specification
using the numbered sequence shown.
Engine / Transmission Mounting Bolts:
Step 1-2: 64 ft-lb (87 Nm)
Step 3: 5 ft-lb (7 Nm)
Step 4-7: 44 ft-lb (60 Nm)
12. Remove the clutch center distance tool.
8
8.9