Polaris 2014 RZR XP 1000 Service Manual page 226

8. Apply Loctite ® 271 ™
circumference of the new upper bearing race. Slide
the new upper bearing onto the steering shaft and
press it into the pivot tube by hand.
NOTE: Use care not to allow any of the Loctite
to get in the bearing.
Bearings will be seated in the pivot housing
upon tightening the steering wheel nut in step
14.
9. Reinstall the upper washers and spacers in the order
in which they were removed.
10. Install the steering wheel and hand tighten the nut.
Apply Loctite ® 271 ™.
11. Reinstall the steering shaft assembly in the vehicle.
Install the lower portion of the steering shaft onto the
steering gear box assembly (see Figure 5-16).
Torque the lower pinch bolt to specification.
Lower Steering Pinch Bolt:
30 ft-lbs (41 Nm)
12. Install the two fasteners that retain the pivot tube
(see Figure 5-17). Torque fasteners to specification.
Pivot Tube Bolts:
23 ft-lbs (31 Nm)
13. Install the fastener retaining the upper portion of the
steering wheel tilt shock to the pivot tube (see Figure
5-17). Torque fastener to specification.
Tilt Shock Bolt:
7 ft-lbs (10 Nm)
BODY / STEERING / SUSPENSION
(Red) to the outer
®
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
14. Be sure the front wheels are facing straight forward.
Remove the steering wheel and align as needed.
Torque the steering wheel nut to specification. Apply
Loctite ® 271 ™
Steering Wheel Nut:
65 ft-lbs (88 Nm)
15. Wipe the pivot tube clean of any excess Loctite
16. Install steering wheel cap and field test steering
operation.
® .
5
5.29