Polaris 2014 RZR XP 1000 Service Manual page 368

16. Torque the locking screw to specification.
Snorkel Locking Screw:
10 ft-lb (14 Nm)
Transmission Assembly
NOTE: The snorkel shaft and pinion shaft must
be installed prior to transmission assembly. The
snorkel shaft cannot
assembling the transmission.
17. Clean both transmission case halves thoroughly.
Inspect case half mating surfaces for damage.
18. Install shift fork (S) and torsion spring into
transmission housing as an assembly. Load spring
as shown in image below
be installed after
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
TRANSMISSION
19. Apply Loctite ® 242 ™ to (2) screws (T) and install with
retaining plates over
specification.
Shift Fork Screws:
10 ft-lb (14 Nm)
20. Slide engagement dog (U) onto retaining pins of shift
fork.
shift fork. Torque to
8
8.39