Polaris 2014 RZR XP 1000 Service Manual page 373

TRANSMISSION
36. Install the detent pawl onto the shift shaft and
carefully install the compression spring.
37. Install a new O-ring on each shift shaft. Apply a small
amount of white lithium grease on the O-rings, shift
shafts and component contact surfaces prior to
installing the sector cover.
38. Clean the transmission and gear sector cover mating
surfaces thoroughly.
39. Apply Crankcase Sealant (3-Bond) (PN 2871557)
onto the cover and transmission case mating
surface.
40. Install the sector cover and align the transmission
case dowel with the alignment hole. Install and
torque the bolts to specification.
Sector Cover Bolts:
12 ft-lb (16 Nm)
8.44
41. Install the transmission drain plug and torque to
specification.
42. Install the bellcrank onto the shift shaft. Note the key
splined on the bellcrank and shift shaft. Install the nut
and torque to specification.
43. Refer to "Transmission Installation" to complete the
repair.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
Fill / Drain Plug:
14 ft-lbs (19 Nm)
Bell Crank Nut:
18 ft-lb (24 Nm)