Resetting The System - Samsung iES4028F Management Manual

3
Configuring the Switch
CLI – Enter the host ip address, followed by the mail severity level, source and
destination email addresses and enter the sendmail command to complete the
action. Use the show logging command to display SMTP information.
Console(config)#logging sendmail host 192.168.1.4
Console(config)#logging sendmail level 3
Console(config)#logging sendmail source-email
big-wheels@matel.com
Console(config)#logging sendmail destination-email
chris@matel.com
Console(config)#logging sendmail
Console(config)#exit
Console#show logging sendmail
SMTP servers
-----------------------------------------------
1. 192.168.1.4
SMTP minimum severity level: 4
SMTP destination email addresses
-----------------------------------------------
1. chris@matel.com
SMTP source email address: big-wheels@matel.com
SMTP status:
Console#

Resetting the System

This feature restarts the system. You can reboot the system immediately, or you can
configure the switch to reset after a specified amount of time.
Command Attributes
• Hours – Specifies the amount of hours to wait, combined with the minutes, before
the switch resets. (Range: 0-576; Default: 0)
• Minutes – Specifies the amount of minutes to wait, combined with the hours,
before the switch resets. (Range: 1-34560; Default: 0)
• Reset – Resets the switch after the specified time. If the hour and minute fields are
blank, then the switch will reset immediately.
• Refresh – Refreshes the countdown timer of a pending delayed reset.
• Cancel – Cancels a pending delayed reset.
3-34
Enabled
4-56
4-57
4-57
4-58
4-58
4-58