Configuring Parameters For Lacp Group Members - Samsung iES4028F Management Manual

3
Configuring the Switch
CLI – The following example enables LACP for ports 1 to 6. Just connect these ports
to LACP-enabled trunk ports on another switch to form a trunk.
Console(config)#interface ethernet 1/1
Console(config-if)#lacp
Console(config-if)#exit
. .
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
Flow control status:
Port security:
Max MAC count:
Giga PHY mode: Auto preferred master
Current status:
Created by:
Link status:
Port operation status:
Operation speed-duplex: 100full
Flow control type:
Member Ports: Eth1/1, Eth1/2, Eth1/3, Eth1/4, Eth1/5, Eth1/6,
Console#

Configuring Parameters for LACP Group Members

Dynamically Creating a Port Channel –
Ports assigned to a common port channel must meet the following criteria:
• Ports must have the same LACP System Priority.
• Ports must have the same LACP port Admin Key.
• However, if the "port channel" Admin Key is set (page 4-142), then the port Admin
Key must be set to the same value for a port to be allowed to join a channel group.
Note – If the port channel admin key (lacp admin key, page 4-207) is not set (through
the CLI) when a channel group is formed (i.e., it has a null value of 0), this key is set to
the same value as the port admin key used by the interfaces that joined the group (lacp
admin key, as described in this section and on page 4-206).
3-138
100TX
00-12-CF-12-34-89
Up
Auto
10half, 10full, 100half, 100full
Disabled
Disabled
0
LACP
Up
Up
None
4-188
4-204
4-197