Clear Counters - Samsung iES4028F Management Manual

4
Command Line Interface
Command Usage
• When traffic exceeds the threshold specified for broadcast and multicast or
unknown unicast traffic, packets exceeding the threshold are dropped until the
rate falls back down beneath the threshold.
• Due to an ASIC chip limitation in the iES4028FP and iES4024GP, the
supported storm control modes include:
- broadcast
- broadcast + multicast
- broadcast + multicast + unknown unicast
This means that when mulicast storm control is enabled, broadcast storm
control is also enabled (using the threshold value set by the multicast storm
control command). And when unknown unicast storm control is enabled, both
multicast and unknown unicast storm control are also enabled (using the
threshold value set by the unknown unicast storm control command).
Example
The following shows how to configure broadcast storm control at 500 kilobits per
second:
Console(config)#interface ethernet 1/5
Console(config-if)#switchport broadcast packet-rate 500
Console(config-if)#

clear counters

This command clears statistics on an interface.
Syntax
clear counters interface
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number.
(Range: 1-28 on iES4028F/iES4028FP, 1-24 on iES4024GP)
• port-channel channel-id (Range: 1-8)
Default Setting
None
Command Mode
Privileged Exec
4-196