Spanning-Tree - Samsung iES4028F Management Manual

Command
spanning-tree mst cost
spanning-tree mst
port-priority

spanning-tree

protocol-migration
show spanning-tree
show spanning-tree mst
configuration
spanning-tree
This command enables the Spanning Tree Algorithm globally for the switch. Use the
no form to disable it.
Syntax
[no] spanning-tree
Default Setting
Spanning tree is enabled.
Command Mode
Global Configuration
Command Usage
The Spanning Tree Algorithm (STA) can be used to detect and disable
network loops, and to provide backup links between switches, bridges or
routers. This allows the switch to interact with other bridging devices (that is,
an STA-compliant switch, bridge or router) in your network to ensure that only
one route exists between any two stations on the network, and provide backup
links which automatically take over when a primary link goes down.
Example
This example shows how to enable the Spanning Tree Algorithm for the switch:
Console(config)#spanning-tree
Console(config)#
Table 4-64 Spanning Tree Commands
Function
Configures the path cost of an instance in the MST
Configures the priority of an instance in the MST
Re-checks the appropriate BPDU format
Shows spanning tree configuration for the common
spanning tree (i.e., overall bridge), a selected interface, or
an instance within the multiple spanning tree
Shows the multiple spanning tree configuration
Spanning Tree Commands
(Continued)
Mode
IC
IC
PE
PE
PE
4
Page
4-244
4-245
4-245
4-246
4-248
4-227