Upnp Configuration; Figure 3-162 Upnp Configuration - Samsung iES4028F Management Manual

3
Configuring the Switch
Using UPnP under Windows Vista –
To access or manage the switch with
the aid of UPnP under Windows Vista,
open the Network and Sharing Center,
and enable Network Discovery. Then
click on the node representing your
local network under the Network
Sharing Center. An entry for the
switch will appear in the list of
discovered devices as shown below.
Right click on the entry for the switch,
and select "View Device webpage" to
access the switch's web management
interface, or select "Properties" to
display a list of device attributes
advertised by the switch through
UPnP.

UPnP Configuration

Use the UPnP Configuration page to enable or disable UPnP, and to set
advertisement and time out values.
Command Attributes
• UPNP Status – Enables/disables UPnP on the device. (Default: Disabled)
• Advertising Duration – This sets the duration of which a device will advertise its
status to the control point. (Range: 60-86400 seconds; Default: 100 seconds)
• TTL Value – Sets the time-to-live (TTL) value for UPnP messages transmitted by
the device. (Range: 1-255; Default: 4)
Web – Click UPNP, Configuration and enter the desired variables.
3-278

Figure 3-162 UPnP Configuration