Sharp MX-M200D Service Manual page 51

Main Sub
code code
26 30 CE mark conformity control ON/OFF
Used to set Yes/No of CE mark conformity.
When this simulation is executed, the current set value is displayed. Enter a value with numeric keys and
press [OK] key or [START] key. The set value is saved to EEPROM and the machine returns to the sub code
input window.
Sim26-30 CE MARK
1:CE MARK CTRL
0=OFF 1=ON
[ 0-1]
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
31 Auditor mode exclusive setup
Used to set whether paper feed is allowed from the manual paper feed tray of not when the auditor is set to
the coin vendor mode.
Sim26-31 AUDITOR
1:AUDITOR
[ 0-2]
* When this setting is set to ON, if the auditor mode is the coin vendor mode and the standard tray setting is
set to the manual paper feed tray, the standard tray setting is set to the main tray.
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
36 Cancel of stop at maintenance life over
"Stop" or "Cancel of stop" can be selected when the maintenance counter reaches the life over.
Sim26-36 MAINTESTOP
1:MAINTE OVER
[ 0-1]
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code entry menu.
37 Cancel of stop at developer life over
"Stop" or "Cancel of stop" can be selected when the developer counter reaches the life over..
Sim26-37 DEVE STOP
1:DEV LIFE OVER
[ 0 - 1]
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code entry menu.
38 Cancel of stop at drum life over
"Stop" or "Cancel of stop" can be selected when the drum counter reaches the life over.
Sim26-37 DEVE STOP
1:DRM LIFE OVER
[ 0-1 ]
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code entry menu.
Contents
Code: Setting
0 : CE mark support control OFF
0
1 : CE mark support control ON
0
Code: Setting
0 : Exclusive setting OFF (Manual paper feed enable)
1
1 : Exclusive setting ON (Manual paper feed disable)
2 : Exclusive setting OFF (Manual paper feed enable) + A3/WLT charge
1
Code: Setting
0 : Stop
1
1 : Cancel of stop
1
Code: Setting
0 : Stop
1
1 : Cancel of stop
1
Code: Setting
0 : Stop
1
1 : Cancel of stop
1
MX-M200D SIMULATIONS 7-22
Remark
Default:
0: 100V series
1: 200V series
Default:
1
Default:
1
Default:
1
Default:
1