Sharp MX-M200D Service Manual page 45

Main Sub
code code
24 02 Trouble memory clear
Used to clear the trouble memory and the trouble history data in the EEPROM.
When [INTERRUPT] key is pressed, the machine shifts to the sub code input window. When [CA] key is
pressed, the machine exits the simulation mode.
Sim24-2 COUNTER CLR
TROUBLE COUNTER
CLEAR
AER YOU SURE? EXEC
04 SPF/RSPF counter clear
Used to clear the SPF/RSPF paper feed counter.
Sim24-4 COUNTER CLR
SPF COUNTER
CLEAR
AER YOU SURE? EXEC
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
05 Duplex print counter clear
Used to clear the duplex print counter.
Sim24-5 COUNTER CLR
DUPLEX COUNTER
CLEAR
AER YOU SURE? EXEC
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
06 Paper feed counter clear
Used to clear the paper feed counter data in each paper feed section.
(Initial window
Sim24-6 COUNTER CLR
1:BYPASS
2:TRAY1
3:TRAY2
* TRAY2-TRAY4 are displayed only when they are installed.
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
07 Drum counter clear
Used to clear the drum counter and the drum rotating time.
Sim24-7 COUNTER CLR
DRUM COUNTER
CLEAR
AER YOU SURE? EXEC
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
(Counter selection window)
Numeric
Sim24-6 COUNTER CLR
Key
4:TRAY3 1:BYPASS
5:TRAY4 2:TRAY1
3:TRAY2
0
[C] Key
MX-M200D SIMULATIONS 7-16
Contents
(Confirmation window)
[OK] key or
Sim24-6 COUNTER CLR
[START] key
4:TRAY3 1:BYPASS
5:TRAY4 2:TRAY1
3:TRAY2
ARE YOU SURE?
2
Return
[OK] key or
[START] key
Remark
(Only when the
SPF/RSPF is
installed.)
(MX-M200D/MX-
M160D only)
(Execution is not
allowed when
DUPLEX setting is
OFF.)
4:TRAY3
5:TRAY4
2