Sharp MX-M200D Service Manual page 44

Main Sub
code code
22 13 CRUM destination display
Used to display the CRUM chip destination code saved in the EEPROM. If the display does not match the
destination code saved in the CRUM chip, it is judged as an error.
* This simulation is valid only for the model with the CRUM chip.
Sim22-13 CRUM
CRUM TYPE
14 P-ROM version display
Sim22-14 ROM VER1/2
S/N : -----------
MCU : --.--
IMC : --.--
PNL : --.--
The version of the option board which is not installed is not displayed.
15 Trouble memory display
The latest 20 troubles are displayed. (The oldest one is overwritten sequentially.)
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
key, key: Switches to another page.
Sim22-15 TROUBLE 1/2
XX-XX XX-XX XX-XX
XX-XX XX-XX XX-XX
XX-XX XX-XX XX-XX
XX-XX XX-XX XX-XX
The display sequence is as shown below.
Sim22-15 TROUBLE 1/2
1 5
2 6
3 7
4 8
In this case, (1) is the latest one and (12) is the oldest.
22 SPF/RSPF jam counter display
Used to display the SPF/RSPF JAM counter.
When [INTERRUPT] key is pressed, the machine goes to the sub code input window. When [CA] key is
pressed, the machine exits the simulation mode.
Sim22-22 JAM CNT
SPF : nnnnnnn
24 01 Jam total counter clear
When this simulation is executed, the clear confirmation window is displayed as shown below.
When [OK] key or [START] key is pressed, the jam total count and the jam memory are cleared and the
machine shifts to the sub code input window.
Sim24-1 COUNTER CLR
JAM COUNTER CLEAR
AER YOU SURE? EXEC
Contents
Number : Setting (Destination)
00 : Not set.
nn
04 : CHN-A
05 : JPN-A
07 : BTA-A
08 : BTA-B
09 : BTA-C
99 : Conversion
Sim22-14 ROM VER2/2
FAX : --.--
Sim22-15 TROUBLE 2/2
key
XX-XX XX-XX XX-XX
XX-XX XX-XX XX-XX
XX-XX XX-XX
key
9
10
11
12
MX-M200D SIMULATIONS 7-15
S/N :Production serial number
MCU :Main unit program version
IMC :IMC program version
PNL :Panel program version
FAX :FAX program version
Remark
(Only when the
SPF/RSPF is
installed.)