Sharp MX-M200D Service Manual page 48

Main Sub
code code
25 10 Polygon motor operation check
When [OK] key or [START] is pressed, the polygon motor is rotated for 30sec.
(Execution start window)
Sim25-10 LSU CHECK
PRESS OK KEY EXEC
After completion of the process, the machine shifts to the sub code input window.
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Interrupts the output operation, and shifts to the sub code input window.
26 01 Job separator setting
Used to set YES/NO of installation of the hob separator.
After installation of the job separator, setting must be manually set to YES.
Sim26-1 JBS SET
1:JOB SEPARATOR
0=NONE
1=SEPARATOR
[ 0-1]
[CA] key: Exits the simulation mode. (When setting is changed, the machine exits the simulation mode and
performs the hard reset.)
[INTERRUPT] key: Shifts to the sub code input window. (When setting is changed, it is invalid.)
[START] key: Setting contents are saved in the EEPROM and the machine shifts to the code input window.
02 Size setting
Used to set Enable/Disable of FC (8.5" x 13") size detection.
Detection size when FC (8.5" x 13") size document is used.
Document
* For destinations other than the above, this setting is invalid.
Sim26-2 SIZE SET
1:B4/LG,FC
0=B4/LG
1=FC
[ 0-1]
03 Auditor setting
Used to set the auditor.
Sim26-3 AUDITOR SET
1:AUDITOR
0=P10 1=VENDOR
2=OTHER
[ 0-2]
* When the coin vendor mode is selected:
1. Sort auto select is OFF.
2. For Japan, the duplex copy use inhibition setting is ON (inhibited).
3. When the auditor mode exclusive-setting is ON (manual paper feed inhibited) and the standard tray is set
to the manual feed tray, the standard tray setting is set to the main tray.
[OK] key or [START] Key
0 : No job separator
0 1 : Job separator provided
0
(When setting is changed, the machine does not shift to the code input window.)
Unit to be Destination
used
SPF/ EX Japan AB
RSPF series(FC)
Inch
series(FC)
Code: Setting
0 : Detection disabled
0
1 : FC detection enabled
0
Code: Mode
0 : Built-in auditor mode
0
1 : Coin vendor
2 : Other
0
MX-M200D SIMULATIONS 7-19
Contents
(Execution window)
Sim25-10 LSU CHECK
EXEC
Document size Set value
0(Disable)
FC(8.5"x13") B4
B4 B4
FC(8.5"x13") LG(8.5"x14")
LG(8.5"x14") LG(8.5"x14")
Default:
(Default for
0:
destinations other
than below
1: Australia,
New Zealand,
1(Enable)
Philippines
FC(8.5"x13")
FC(8.5"x13")
FC(8.5"x13")
FC(8.5"x13")
Default:
0
Remark
)