Camshaft - Mitsubishi S3L Service Manual

INSPECTION
Figure 81 Measuring camshaft journal
Figure 82 Measuring bore in camshaft bushing
Front of cylinder
block
Camshaft Bushing
Installer
Figure 83 Removing camshaft bushing
Service Manual Mitsubishi SL-Series diesel engines
Version 08/2004

18.1 Camshaft

1.
Measure the diameter of the journal and the bore in the
bushing for the shaft to find the clearance as shown in
the illustration. If the clearance exceeds the limit,
replace the bushing.
2.
Camshaft
Use Camshaft Bushing Installer (ST332340) (special
bushing
tool) for camshaft bushing replacement.
ENGLISH
TIMING GEARS AND FLYWHEEL
Clearance between journal and bushing
Item
Clearance between
camshaft journal and
bushing
Bushing replacement
1) Removal
Remove the oil pan. Using a "remover" end of
the Installer, push out the bushing into the
cylinder block. Crush and take out the
bushing from the block.
Unit: mm (in.)
Standard
0.15 (0.005 9)
67 / 195