Sliding Sleeve Installation; Governor Assembly Installation; Fuel Injection Line Installation - Mitsubishi S3L Service Manual

ASSEMBLY
Figure 170 Installing sliding sleeve
Figure 171 Installing governor assembly
Figure 172 Installing fuel injection lines
Service Manual Mitsubishi SL-Series diesel engines
Version 08/2004

24.4 Sliding sleeve installation

Install the sliding sleeve on the sliding sleeve shaft and
make sure the sleeve moves freely.
24.5 Governor assembly
installation
1. Install the governor assembly in position while
putting the tie rod and spring into position in the
injection pump.
2. Install the tie rod to the pin of the control rack and
secure it with the tie rod spring.
3. Install the tie rod cover in position.

24.6 Fuel injection line installation

1. Put the fuel leak-off line in position and connect it
to the fuel injection nozzles.
2. Put the fuel injection lines in position and connect
them to the fuel injection pump. Install the clamps.
ENGLISH
Fuel System
105 / 195